BD Vape x Hirano Designs Droid RDTA Boro Tank

Hirano Designs

$49.99 USD

Shipping calculated at checkout

Available Now!

BD Vape x Hirano Designs Droid RDTA Boro Tank

Designed in the USA

BD Vape x Hirano Designs presents the Droid RDTA Boro Tank. The Droid is a RDTA style atomizer specifically for Boro box style mods. The Droid features a top mounted two post build deck, interchangeable airflow pins, stainless steel cable wicking, and a unique tank design that holds 5.5ml of vape juice with a front fill silicone plug.

The Droid RDTA is constructed from stainless steel with PCTG tank section. The build deck features an easy-to-build two post build deck with top mounted flat head capture screws. Wicking is achieved through the use of stainless steel cables, which continuously feed up to the cotton when the coil is fired. The chamber of the top cap has been optimized to allow a wide range of coil sizes, while minimizing chamber space for maximum flavor delivery. Air is brought into the Droid via a front airflow slot with interchangeable pins [MTL:0.8mm, (2x)0.8mm, (3x)0.8mm, (4x)0.8mm, RDL:0.8x2.8mm, 0.8x4.4mm DL: 1.5x5mm, 1.5x5mm + (2x)2.5mm (no pin)] to adjust air volume.

Why a RDTA style tank for Boro Box Mods?

The Droid was designed to offer the same great flavor experience often associated with Boro Box Mods and RBA Bridge setups, but without the hassle that comes with it. By positioning the build deck at the top of the tank, there is no need to empty the tank to rebuild or change cotton. Hirano Designs also wanted to have the ability to share a similar experience as using a RDA, but in a Boro Box setup. The shorter vapor travel distance of a RDTA allows for a much warmer and direct hit that you would get from a traditional RDA.

Pro Tip: The Droid performs differently from most other atomizers due to the high coil position relative to the drip tip, the airflow design, and small chamber space. It is recommended to run your wattage 3-7W lower than you normally would. The balance of airflow may change depending on your device: for closed devices such as the Billet Box, Cthulhu AIO, KUKA AIO, Vidar, etc; use an airflow pin which is 1-2 sizes larger to compensate for the indirect airflow pathway.

Product Includes:
  • 1 x Droid RDTA
  • 7 x Airflow Pins  [MTL:0.8mm, (2x)0.8mm, (3x)0.8mm, (4x)0.8mm, RDL:0.8x2.8mm, 0.8x4.4mm DL: 1.5x5mm, 1.5x5mm + (2x)2.5mm (no pin)]
  • 1 x 510 Adapter
  • 1 x Spare Parts Bag
  • Stainless Steel and PCTG Construction 
  • 5.5ml Capacity
  • Center Front Fill
    • Silicone Plug
  • Two Post Build Deck
    • Flat Head Capture Screws
  • SS Cable wicking
  • Interchangeable Airflow Pins
    • MTL:0.8mm, (2x)0.8mm, (3x)0.8mm, (4x)0.8mm
    • RDL:0.8x2.8mm, 0.8x4.4mm
    • DL: 1.5x5mm, 1.5x5mm + (2x)2.5mm (no pin)